It's FRI-YAY! Who doesn't like a nice cocktail? And what do you need with your nice cocktails? A mahogany pallet coaster! When you are all done, you're going to need a place to put them, so the Mrs. doesn't yell at ya, right? Gotta clean up after yourself, guys. Well here is the perfect solution... your very own mahogany pallet coaster holder!
Supplies needed:
- 1 - Set of 5 Mini Mahogany Pallet Coasters
- 1 - Mini stained wood plank
- 2 - Mini 4x4s
- power drill
- wood screws
- red mahogany wood stain
- wood cutter
- measuring tape
- sharpie
Here are the steps to build your very own pallet coaster holder!
Step 1:
Mark your stained wood plank at 2cm away from each side with your sharpie.
Step 2:
Make sure that your coasters will fit within the markings.
Step 3:
Use your drill bit to make the holes for your screws.
Step 4:
Place all five coasters onto the stained wood plank and place a marking on your 4x4s at the appropriate height. I marked mine at 9cm each. Use our craft cutter, or another hand tool to saw the 4x4s.
Step 5:
Now you are ready to stain your individual 4x4s. Make sure that they are completely dry before moving on to the next step.
Step 6:
Use your drill bit again to make holes in the center of each of the bottoms of the 4x4s. This will help guide the screws.
Step 7:
Now you are all ready to start screwing in the wood screws into the stained wood plank.
Step 8:
All you have to do now is screw on the 4x4s, and you are all done!
Have fun y'all!